Segregation in concrete
This article may be too technical for most readers to understand. (May 2012) |
Segregation in concrete is a case of particle segregation in concrete applications, in which particulate solids tend to segregate by virtue of differences in the size, density, shape and other properties of particles of which they are composed. when the workability of concrete is high under pouring conditions, or the amount of mortar is larger than the void volume of coarse aggregate, or the particle size of aggregate is not ideal, excessive vibration can cause segregation bleeding or lighter weight[1]
Definition
[edit | edit source]It is described by American Society for Testing and Materials as follows: "Segregation in concrete is commonly thought of as separation of some size groups of aggregates from cement mortar[nb 1] in isolated locations with corresponding deficiencies of these materials in other locations. Segregation results in proportions of the laid concrete being in variation with those designed.[3]: 38 Segregation could result from internal factors such as concrete that is not proportioned properly and not mixed adequately, or too workable a mix. It also could result from external factors such as too much vibration,[nb 2] improper transportation, placement, or adverse weather conditions.[4]: 7, 8 The corresponding increase in proportion of cement paste in upper areas would tend to make them susceptible to increased shrinkage and formation of cracks. These cracks could be 10 μm to 500 μm wide, formed perpendicular to the surface, and be in the form of map patterns."[5]: 149
The concrete should be free from segregation. It is defined as the breaking up of cohesion (separation of concrete aggregate) in a mass of concrete. It results in honey-combing, decrease in density, and ultimately loss of strength of hardened concrete. The effect of aggregate segregation on the mechanical and transport behavior of concrete has been the focus of both modeling as well as experimental investigation.
See also
[edit | edit source]Notes
[edit | edit source]- ^ Mortar is a mixture of fine aggregates and cement, that in concrete acts as a binder between particles of coarse aggregates.[2]: 119, 120
- ^ Compaction describes the process employed to obtain maximum density in concrete after it has been deposited in place. Compaction could be achieved by mechanical vibrators, devices that vibrate at various frequencies and which transfer these vibrations to concrete.[2]: 144
References
[edit | edit source]- ^ Lua error in Module:Citation/CS1/Configuration at line 2172: attempt to index field '?' (a nil value).
- ^ a b Lua error in Module:Citation/CS1/Configuration at line 2172: attempt to index field '?' (a nil value).
- ^ Lua error in Module:Citation/CS1/Configuration at line 2172: attempt to index field '?' (a nil value).
- ^ Lua error in Module:Citation/CS1/Configuration at line 2172: attempt to index field '?' (a nil value).
- ^ Lua error in Module:Citation/CS1/Configuration at line 2172: attempt to index field '?' (a nil value).
Further reading
[edit | edit source]- Lua error in Module:Citation/CS1/Configuration at line 2172: attempt to index field '?' (a nil value). Lua error in Module:Citation/CS1/Configuration at line 2172: attempt to index field '?' (a nil value).
- Towards a realistic morphological model for the meso-scale mechanical and transport behavior of cementitious composites Davood Niknezhad; Balaji Raghavan; Fabrice Bernard; Siham Kamali-Bernard; Composites Part A: Engineering, Volume 381, 72–83, 2015 Elsevier
External links
[edit | edit source]- Segregation in concrete - from Civil Experiences
- Lecture 12: Module 5 Lecture - 4 Fresh Concrete : Segregation & Bleeding – from the Indian Institute of Technology, Delhi
